IBM 2005-H16光钎交换机密码重置

15-10-12 来源：[db:作者]

收藏我要投稿

若factory或者root用户还是默认密码，就用这两个用户其中一个以串口登陆交换机，然后passwordadmin，根据提示就可以更改密码了，也可以直接用passwddefault命令将全部账户重置为出厂密码

admin/password

root/fibranne

factory/password

如果密码确认都修改过了，只能通过串口连接设备，然后重新启动设备，然后前5秒按ESC，进入单用户方式进行重置

1. Connect console cable to yourlaptop and SAN Switch

2. Open HyperTerm or Putty and connect to COM1and restore Port Setting to default

3. Power recycle the SAN Swithch switch offand switch on

4. Press ESC when POST messages are displayed

5. The Boot PROM Menu will be shown as below:

1) Start System

2) Recover Password

3) Enter command shell

6. Choose 3 and press enter to open command shell

7. Type printenv

8. Look for the line started with OSLoader http://e.g *OSLoader=MEM()0xF0000000;*MEM()0xF08000000

9. Copy the text between = and ; which isMEM()0xF0000000

10. Type boot MEM()0xF0000000 –s

11. Type mount -o remount,rw,noatime /

12. Type mount /dev/hda2 /mnt

13. Type /sbin/passwddefault

14. You will be informed passwords are set todefault

15. Type reboot -f and switch will be rebooted

16. Wait for Swith to be normally rebooted andlog in as root. Default password in my case is fibranne

17. You will be prompted to change passwordfor root, factory and admin account and do so as prompted

18. Document the password somewhere safe anddisconnect console connection

附件是一次重置H16密码的详尽操作记录。